[Triumph Logo]

Help 9: Rust Never Sleeps!!!



If you are in the process of painting your scooter or are having problems of clogging of motorcycle carburetors. Get a flashlight. Look inside the tank. If rust is present, stop and seal that tank!!! Make the inside of your tank look as good as the outside.

Repeated clogging of motorcycle carburetors may indicate the gas tank of your cycle is in need of attention. Any signs of rust or black residue on the insided is an indication that a cleaning is overdue. The tank needs to be removed and at least cleaned. Some people recommend that filters be placed in the gas lines to the carburetors. I believe this is just postponing the inevitable. There are a few companies that manufacture kits to seal the inside of your tank. This is a much more perminate solution.

If the instillation of one of these kits is decided, there is one secret ingredient that is critical to success, this ingredient is patience. Read the instructions carefully and follow them. This is critical to form an even coat of sealer on the inside of the tank. POR 15 makes a kit for motorcycles that works well. The kit is a three stage process. First, the tank is cleaned. Rust is then removed and a coating of zinc phosphate is readied in the next step. And last, a sealer is applied to the inside of the tank. This sealer will seal any holes or cracks in the tank.

The mistake I see most is NOT WAITING LONG ENOUGH FOR THE TANK TO DRY after the prepping of the tank (steps 1 and 2). This can cause the liner to separate from the wall of the tank! Also, don't be in a hurry after you pour the sealer in the tank. The tank needs to be rotated constantly while the sealer in the tank is coating. This assures that the inside of the tank is completely sealed and applies second and third coats to the inside of the tank. Short breaks between the rotating of the tank maybe necessary to let the sealer dry, but keep rotating until no signs of fluid is noticeable. Last but not least, when you are sure that the inside is completely coated (use a flashlight to view the inside) leave the tank at rest on the side of the tank with the most rust/damage. This will most likely be the bottom of the tank. For questions or to order this product contact me.

The cost of this product is nominal. POR 15 normally costs less than the cost of the paint for the tank.

If you do not heed my advice, at least carry duct tape around to seal the leeks. Remember: Rust Never Sleeps!!!

Keep it down the Road,
Joe


Return to BBC Home Page